7.5.1.6 show ip pim rp-hash
This command displays which rendezvous point (RP) is being used for a specified group.
Syntax
show ip pim rp-hash <group-address>
<group-address> - the multicast group address for the start of the range of addresses to be
excluded. The address must be in the range of 239.0.0.0 through 239.255.255.255.
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Message
RP Address: The IP address of the RP for the group specified
Type: Indicates the mechanism (BSR or static) by which the RP was selected
7.5.1.7 show ip pim ssm
This command displays the configured source specific IP multicast addresses. If no SSM Group range is
configured, this command output is No SSM address range is configured.
Syntax
show ip pim ssm
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Message
Group Address: The IP multicast address of the SSM group
Prefix Length: The network prefix length
To Next Page
Loading...