Quanta Computer QuantaMesh - Page 864

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | IP Multicast Commands
864
7.5.2.2 ip pim dense
This command enables the administrative mode of PIM-DM in the router.
Syntax
ip pim dense
no ip pim dense
no - This command disables the administrative mode of PIM-DM in the router.
Default Setting
Disabled
Command Mode
Global Config
7.5.2.3 ip pim rp-address
This command is used to statically configure the RP address for one or more multicast groups. The
parameter rp-address is the IP address of the RP. The parameter groupaddress is the group address
supported by the RP. The parameter groupmask is the group mask for the group address. The optional
keyword override indicates that if there is a conflict, the RP configured with this command prevails over
the RP learned by BSR.
Syntax
ip pim rp-address <rp-address> <group-address> <group-mask> [override]
no ip pim rp-address <rp-address> <group-address> <group-mask>
<rp-address> - Specifies the rp address.
<group-address> - Specifies the group address.
<group-mask> - Specifies the group mask.
no - This command is used to statically remove the RP address for one or more multicast groups.
Default Setting
0
Command Mode
Global Config