Quanta Computer QuantaMesh - Page 885

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | IP Multicast Commands
885
7.6.2.12 ipv6 pim ssm
Use this command to define the Source Specific Multicast (SSM) range of IPv6 multicast addresses on
the router. Note that this command takes effect only when PIM-SM is configured as the PIM mode.
Syntax
ipv6 pim ssm {default | <group-address>/< prefix-length >}
no ipv6 pim ssm {default | <group-address>/<prefix-length>}
default - Defines the SSM range access list FF3x::/32.
no - This command is used to disable the Source Specific Multicast (SSM) range.
Default Setting
Disbaled
Command Mode
Global Config