Quanta Computer QuantaMesh - Page 918

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | IPv6 Commands
918
8.3.2.3 ipv6 enable
Use this command to enable IPv6 routing on an interface, including a tunnel and loopback interface that
has not been configured with an explicit IPv6 address. When you use this command, the interface is
automatically configured with a link-local address. You do not need to use this command if you
configured an IPv6 global address on the interface.
Syntax
ipv6 enable
no ipv6 enable
no – Use this command to disable IPv6 routing on an interface.
Default Setting
Disabled
Command Mode
Interface Config
Interface VLAN