Quanta Computer QuantaMesh - Page 962

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | IPv6 Commands
962
8.4.2.24 area virtual-link hello-interval
This command configures the hello interval for the OSPF virtual interface on the interface identified by
<areaid> and <neighborid>.
Syntax
area <areaid> virtual-link <neighborid> hello-interval <1-65535>
no area <areaid> virtual-link <neighborid> hello-interval
<areaid> - Area ID.
<neighborid> - Router ID of the neighbor.
<1-65535> - The range of the hello interval is 1 to 65535.
no - This command configures the default hello interval for the OSPF virtual interface on the
interface identified by <areaid> and <neighborid>.
Default Setting
10 seconds.
Command Mode
Router OSPFv3 Config