Layer 2/3/4 Managed Switch
QuantaMesh | IPv6 Commands
set ipv6 next-hop <ipv6-address>
no set ipv6 next-hop
Default Setting
None.
Command Mode
Route Map Config
Parameter
Ipv6-address: The IPv6 address set as the Network Address of Next Hop field in the MP_NLRI
attribute of an UPDATE message.
8.6.2.4 clear ipv6 prefix-list
Use this command to reset and clear IPv6 prefix-list hit counters. The hit count is a value indicating the
number of matches to a specific prefix list entry.
Syntax
clear ipv6 prefix-list [prefix-list-name] [ipv6-prefix/prefix-length]
Command Mode
Privileged Exec
Parameter
prefix-list-name: (Optional) Name of the prefix list from which the hit count is to be cleared.
ipv6-prefix/prefixlength: (Optional) IPv6 prefix number and length (in bits) of the network mask. If
this option is specified, hit counters are only cleared for the matching statement.
To Next Page
Loading...