CubiScan 110-T 4
Chapter 2
Setup
This chapter provides instructions for assembling and setting up the
CubiScan 110-T. Perform the steps to set up the CubiScan 110-T in the
following order:
• Unpack the CubiScan (page 4)
• Set up the back panel (page 6)
• Adjust the shipping bolts (page 7)
• Place the CubiScan where you will be using it (page 8)
• Connect power to the CubiScan (page 9)
• Turn on the CubiScan 110-T (page 10)
• Connect the CubiScan to a computer or network (optional) (page 10)
• Connect the CubiScan to a barcode scanner (optional) (page 13)
• Install the Qbit for Windows PC software (optional) (page 15)
Unpacking
To unpack the CubiScan 110-T, take the following steps.
1. Remove the top of the crate.
To Next Page
Loading...
