CubiScan 110-T 21
Chapter 4
Configuration
This chapter provides instructions for using the CubiScan 110-T
touchscreen to set up the height, width, and length measurements,
configure the units, dimensional weight factor, and other settings.
If you have a computer connected to the CubiScan 110-T with Qbit
installed, you can use Qbit to set up the measurement and dimensional
weight units, perform calibration, and other functions. Refer to the Qbit
User Guide for instructions on measuring and other functions in Qbit. The
Qbit User Guide is provided on the CD-ROM with the Qbit application, or
you can download it from the Quantronix website at www.cubiscan.com
.
System Configuration
The following options can be used to configure your CubiScan 110-T. The
options available on the configuration menu are Operation, Units,
Ethernet, and Other.
Operation
This section discusses the options available on the operation menu.
Complete the following steps to access the operation menu.
To Next Page
Loading...
