Setup Adjusting the Shipping Bolts
CubiScan 110-T 7
5. Route the height sensor cable up the channel on the back panel, and
insert the plug into the socket on the height sensor.
Adjusting the Shipping Bolts
Three shipping bolts are located on the CubiScan base to anchor the scale
to the base. The bolts must be tightened after shipping for proper operation
of the scale. Complete the following steps to adjust the shipping bolts.
1. Carefully tip the CubiScan 110-T onto the back panel to expose the
bottom of the scale.
Figure 4
Sensor Cables
To Next Page
Loading...
