Setup Setup Checklist
CubiScan 110-T 16
• Is the CubiScan free moving? The CubiScan should not be pushed up
against a wall and no object, cable, etc., should be resting on it or against
it. (page 8)
• Has the AC power adapter been connected correctly? (page 9)
• Has the CubiScan 110-T been set up to communicate with a computer (if
applicable)? (page 10)
• (Optional) Has the barcode scanner been connected properly? (page 13)
• If you are using Qbit to operate the CubiScan 110-T, has the application
been copied onto your computer’s hard-disk drive? (Refer to the Qbit
User Guide for information.)
• Does the CubiScan require recalibration? The CubiScan 110-T was
calibrated at the factory, but may require recalibration due to handling
during shipping. Refer to page 34 for information on calibrating the
CubiScan 110-T. If you are using Qbit software, check the status of the
CubiScan before operating it. Refer to the Qbit User Guide for
information on checking the CubiScan’s status.
To Next Page
Loading...
