Quantum Systems VECTOR - Page 115

115
Troubleshooting
AIRSPEED ERROR An airspeed sensor error occured
during the preight check or
during the transition.
Possible reasons are a transition
with tail wind or a blocked air-
speed sensor tube.
During preight check:
1. Disconnect the battery from the UAV and connect it again.
During ight: Two options are available
• Select Come Home – the UAV returns to the home waypoint.
• Select Continue – the UAV will continue the mission in downgraded Fixed Pitch
Mode (without airspeed data, with a reduced efciency)
During transition:
1. The transition is aborted and the UAV returns to the home waypoint.
2. Please land the UAV manually at the home waypoint by carefully pullling the left
stick towards you.
AIRSPEED
INITIALIZATION
ERROR
Sensor Init Error during Startup Disconnect the battery from the UAV and connect it again.
ASSISTED FLIGHT The UAV is controlled manually in
assisted mode.
Control the UAV according to the commands of the assisted mode
or select Continue to switch to automatic mode.
AUTOPILOT INFO
ERROR
Autopilot conguration error. Contact your sales agent.
BARO ERROR A baro sensor error occured du-
ring the preight check.
1. Disconnect the battery from the UAV and connect it again.
2. Repeat the preight check.
BARO
INITIALIZATION
ERROR
Sensor Init Error during Startup Disconnect the battery from the UAV and connect it again.
BATTERY CRITICAL During Preight Check: The re-
maining battery capacity is below
minimum.
During Flight: The remaining
capacity is needed to return and
to land.
The UAV initiates a coming home automatically.
Please land the UAV manually at the home waypoint by carefully pulling the left stick
towards you.
BATTERY LOW During Preight check: An error
appears during preight check.
Please charge the battery.
During igth: A warning 10 minutes
before the UAV returns home due
to battery capacity.
Please select Come Home.
12