© İnnosis Makine 15
The loading and unloading of the machine on the vehicle happens with the help of ramps
(showed in the gure 3) anchored on the vehicle.
Using a Crane is not recommended for loading or unloading the machine
This process can be done via two dierent funcons, manually or with the remote control unit.
We highly recommend using remote control, as it is deemed to be the safest pracce.
It is the user’s responsibility to do their workplace risk assessment based on their country’s
health and safety work act/law/regulaons. It is highly recommended users contact local
authories in this maer. (Please see example on page 74)
Both operaons (loading and unloading) always involve high-risk situaons so it is necessary
to use a lot of cauon during the transporng and to observe, always, the following
precauons:
• Prior to any transporng make sure that it all acvity is happening on at ground and in
a safe distance from the edge the edge of ditches and steep slopes.
Fig.4 Pile driver anchoring point
Using ramps for loading/unloading
• It is crucial to assure that ramps have sufficient hanging load strength equivalent to the total
weight of the pile driver, quoted on the identification plate
To Next Page
Loading...