Quantum 800 - Programmed Maintenance

© İnnosis Makine 45
Be careful concerning the loss of uids under pressure and the excess vibraon of the pipes. This
means that the nitrogen in the hammerhead is not sucient. Proceed immediately with the
loading process as described in the appropriate manual of the hammer.
1.2- Programmed maintenance
Daily check, (please use the Start Up Check List supplied on Page 86 or your company document)
Daily check (Example)
Do the following checks every day or aer 8 (eight) operang hours:
• Check if there are any hydraulic oil leaks or dras present
• Check the automac return of the control levers and the carrying out of all the
funcons
• Check the level of the engine oil
• Check the hydraulic oil level in the tank
• Make sure that the motor reducers work well
• Check the ghtening of the crawler tracks
• Apply grease to all the present grease cups on the pile driver with the special hand
pump.
• Check to ensure the tracks are clean of stone or rocks.
• Check the placement arm for wear.
• Check the electric magnecs are clean and undamaged.
• Consult the manual of the engine and the hammer for the appropriate maintenance.
Weekly check (Example)
Do the following checks every week or aer 40 - 50 operang hours:
• Check if there are any hydraulic oil leaks or dras present. If yes, check and ghten.
• Check the automac return of all control levers and ensure all are funconal.
• Check the level of the engine oil by using the dipsck.
• Check the hydraulic oil level in the tank by using the sight glass, should be ½ ll or
greater.
• Check the ghtening of the crawler tracks if required, Do Not Over Tighten
• Apply grease to all the present grease cups on the Pile Driver with the handheld grease
pump.
• Clean the li chain, and apply oil as required.
• Check the anchorage pins at each end of the li chain for wear and replace them if
damaged.
Replace every 12-month period.