Quantum 800 - 6- Troubleshooting

© İnnosis Makine 55
6- TROUBLESHOOTING
FAILURES
CAUSES
REMEDIES
Crawler tracks:
Loosening of the crawler track
Lack of grease
Apply Grease to ghten
Tightening valve defect
The seal on the slack adjuster is
damaged
Replace the valve
Replace the seals in the slack
adjuster
Replace the worn-out components
The superior part of the crawler
track doesn’t maintain the original
posion anymore
Guide slide crawler track worn-out
Rollers are worn-out
Replace the guide slide
Replace rollers
The crawler track locks in the
steering phase
Spoil like stones, gravel may be
between rollers, crawler wheel, and
the rubber crawler track
Clean the material out. Rotate the
crawler track in both direcons,
slacken the ghtening a lile, and if
it is possible li the machine up.
Motor drives:
See the concerning use and
maintenance manuals supplied
enclosed to this one.
Engine:
The Diesel engine doesn’t start
(battery and oil indicators off)
Battery unloaded
Fuse, placed inside the starter
frame, interrupted
If, after having checked the
battery and/or the fuse, the engine
still doesn’t start, it will be
necessary to check the whole
wiring of battery/starter
board/engine. If this turns out
negative, please have a look at
the use and maintenance manual
of the engine
Load or replace the battery
Replace the fuse (20 amp)
Replace the wiring