Quantum 800 - 6- Request of Spare Parts; 7- Differentiated Material Splitting and Disposal in Case of Demolition

© İnnosis Makine 59
Oil leak from a connecon
Slow connecon Gasket wear-out
Tighten the tube
Substute the gasket
Hammer:
The tubes of the hammer vibrate
excessively.
The nitrogen accumulator is empty or
lost pressure
Note:
For all the other inconveniences
concerning the hammer, please check
the use and maintenance manual of
the hammer
Check the nitrogen cartridge in
the accumulator or re-establish
it.
IMPORTANT: It is advisable to
react immediately in order not to
perforate the diaphragm or
damage the tubes.
Note: For all other failures or inconveniences not menoned in the schedule above, always contact The
manufacturer.
6- REQUEST OF SPARE PARTS
For requesng the spare parts always menon:
• The idencaon model, serial number, and construcon year from the nameplate
• The descripon of the part against the parts manual or supply a photo of the part
• The quanty of the requested parts.
The reparaons, maintenance and substuons of parts not described in this manual, are not
covered by the warranty and the Manufacturer is not responsible for the poor operang of the
machine and the eventual consequences due to the use of these parts.
7- DIFFERENTIATED MATERIAL SPLITTING AND DISPOSAL IN CASE OF
DEMOLITION
When the pile driver is out of funcon, the parts, which could be hazardous for people, animals
or the environment if dispersed, must be made harmless. The material of the machine which
must be subdivided is: