Quantum 800 - Page 58

© İnnosis Makine 58
The diesel engine starts, but aer a
few seconds it turns o
Emergency buon acvated
The lever for hammer acvaon lever
has been le in posion A or B (see
gure 14 page 33) and blocked at the
end point
If aer having checked the emergency
buon and the lever for hammer
acvaon and aer having started the
engine again the result is sll negave,
please have a look at the use and
maintenance manual of the engine
Deacvate the emergency
buon (rotate slowly clockwise)
Release the lever from posion A
or B (it returns automacally in
the neutral posion)
FAILURES
CAUSES
REMEDIES
Pile driver(connued)
The distributor control levers do not
work
Lack of oil
Damaged or not connected tubes in
the hydraulic system
Hydraulic pump damaged
Filter clogged
Add oil
Substute or connect the tubes
Substute the pump
Substute the lter
The jacks move in jerks
Air in the hydraulic circuit
Make the machine working
unoccupied for a while, using one
by one all the jacks to exit the air
le in the hydraulic circuit
A jack moves without acvang the
lever
Blocking valve jammed
Jack gasket wear-out
Distributor gasket wear-out
Substute the valve
Substute the gaskets
Substute the gaskets
Oil overheang
Filter clogged Tubes squashed
Lack of oil
Substute the lter
Check and substute the tubes
Add oil