Quantum 800 - Page 57

© İnnosis Makine 57
The Arm move in jerks
Air in the hydraulic circuit
Make the machine work
unoccupied for a while, using
each function until the air exit
the hydraulic circuit.
The Arm moves without activating
the lever
Blocking valve jammed
Jack gasket wear-out
Distributor gasket wear-out
Change the lever and maybe
the gaskets
Oil overheating
Filter clogged Tubes squashed
Lack of oil
Substitute the filter
Check and substitute the tubes
Add oil
Oil leak from a connection
Slow connection Gasket wearout
Tighten the tube Substitute the
gasket
FAILURES
CAUSES
REMEDIES
Pile driver:
The Diesel engine doesn’t start
(baery and oil indicators o)
Baery unloaded
Fuse, placed inside the starter frame,
interrupted
If, aer having checked the baery
and/or the fuse, the engine sll
doesn’t start, it will be necessary to
check the whole wiring of
baery/starter board/engine. If this
turns out negave, please have a look
at the use and maintenance manual of
the engine
Load or replace the baery
Replace the fuse (20 amp)
Replace the wiring
The diesel engine doesn’t start
(baery and oil indicators on)
Electric stop device broken
If the electric stop device has been
removed, the connecons are wrong
Aer having checked the emergency
buon and/or the electric stop device
it will be necessary to check the whole
wiring of the emergency
buon/electric stop device/engine. If
that results negave, please have a
look at the use and maintenance
manual of the engine
Replace electric stop device
Carry out the connecons
following the electrical schedule
enclosed
Replace the wiring