© İnnosis Makine 33
Heat exchanger: (It is not a standard accessory - installed only on request). The heat
exchanger or more commonly called oil cooler is a device used for cooling hydraulic oil,
in the unloading phase, before it reaches the tank. The exchanger, supplied electrically, is
acvated by a thermic sensor that constantly points out oil temperature when it reaches
80°C. Under this temperature the exchanger doesn’t work. Watching the appropriate
thermometer, placed outside the tank, can easily carry out the temperature check.
3.3 Remote Control
Operating procedure for Quantum Remote Control Unit
• All controls are clearly marked with the function.
• To turn it on, push the Green and hold until the light shows
• Lights are left and right of the switch
• Once lights are on, push the black button once, then following by the
green button again – you are now connected
• Operate the remote in the normal fashion
• At the end of the day push the green button to turn off
• The battery should be rechange at the end of each day
• The RED button is the Estop
To Next Page
Loading...