Quantum 800 - 4- Engine and Hammer Check; 5- Battery and Electrical System Check

© İnnosis Makine 54
IMPORTANT: To avoid polluon, it’s absolutely forbidden to disperse oils, lubricants, lter
cartridges or other noxious materials in the environment. Comply strictly with the instrucons
in force for the disposal of liquids or solid substances.
4- ENGINE AND HAMMER CHECK
Engine
For the oil level check of the engine and/or its substuon, for the check and/or the
substuon of the concerning lter and for all the other checks concerning the engine, we
recommend following all the instrucons contained in the proper use and maintenance
manual.
Hammer
For the check and/or re-establishment of the charge of nitrogen in the accumulator and for all
the other checks concerning the hammer, we recommend following the instrucons in the
proper use and maintenance manual of the hammer.
5- BATTERY AND ELECTRICAL SYSTEM CHECK
Baery
Carry out the check of the electrolyte level of the baery with the engine o and with the pile
driver parked on at ground. The level of every element should be about 6 mm above the border
of the plates. When it’s necessary to re-establish the level, add dislled water, wearing
waterproof gloves. It’s beer to add the water before starng the work. Check if the connecng
chucks aren’t oxidised. If they are, clean and grease them with anoxidant grease or substute
them.
Electrical system
The electrical system does not require special maintenance. Therefore, the good operaon of
the machine is a constant check of the machine itself. There are some components that, even if
they have an independent circuit of operang regarding the machine, must be tested
periodically. These components are the emergency buon, the trac indicator, and the outlet.