© İnnosis Makine 19
There is a risk of injuries to operator’s feet by the rubber crawler tracks in the standing
posion. When the machine engine is o, the protecon screen protects the starter frame and
the control panel placed in its vicinity.
Aer preliminary controls and lowering the protecon screen, the operator needs to place the
accelerator to about ¼ of its range and then eect the starng. The operator should follow the
instrucons in the manual of use and maintenance of the engine. When the machine is on, it
is advisable to wait some minutes, so the engine oil and the hydraulic oil will reach on the
opmal temperature.
It is advisable to check on all the funcons of the machine by manoeuvring one funcon at a
me, before starng the daily task to make sure that everything is funconing well. The operator
should have a good realisaon of a precise funcon, as for example the column orientaon
should be retracted.
IMPORTANT:
It is essenal for the operator to observe all the safety rules as described earlier. In case he is
working alone in an area, safety policy and procedures for lone worker must be applied. Missing
observance of the safety precauons and rules may cause serious harm or even death.
2-4 Operaonal
The pile driver should be used only for the driving of guardrail and solar posts, or to carry out
some other specic funcons, being described in the next chapter, upon installaon of
equipment manufactured by Quantum only. Therefore, dierent funcons such as applicaon
of inadequate or not-tested equipment and not of Quantum manufacturer are considered as
improper and are consequently forbidden.
The machine works with safety devices and technical characteriscs, which have been
elaborated during the development phase respecng all the appropriate safety rules. Customers
cannot alter the technical characteriscs of the pile driver for the modicaon of its
performance. If this should happen anyway, the warranty of the machine as well as the
responsibility of the manufacturer will immediately void.
To Next Page
Loading...