© İnnosis Makine 16
• Before starting any loading and movement, it is essential to assure cleanliness of the ramp
surfaces from trace of oil, grease, ice or soil
• Make sure that ramps are firmly anchored to the vehicle, placed parallel to each other and
positioned with an angle of maximal 30°
• After loading, make sure that the vehicle’s engine is off and the machine must be
immobilized by means of tie rods or chains attached in the rings or points of anchorage or
lifting
• Make sure of using appropriate signals like relative pictograms (representing a hook), like
those showed in the figure 4
• Make sure the transporting vehicle is blocked with wedges placed in front and behind every
wheel (figure 4)
Both loading and unloading operaons require to be carried out by qualied/competent
personnel, trained for the job and with full regard to the safety rules. The manufacturer’s
responsibility such as warranty will void immediately, in case an accident happens because of
lack of safety precauons.
It is important to assure a precise conguraon of transport and movements in order to keep
weight balance on the movement and liing operaon. This can be achieved at best pracce
a) If extended, return the slide completely retracng the relave ram at the end stop point
b) Return the column completely by retracng the relave ram at the end stop point
c) At the end, set down carefully the enre column in its rest posion, retracng the relave the
operator should lower the protecon screen (oponal) to have access to the starter frame,
placed on the basis level as shown in the gure. Such screen is designed and applied on the
machine essenally for the protecon of the operator when he stands by the control post and
the machine is in movement, against feet injuries that could be caused by the rubber crawler
tracks. At the same me, when the machine is sll and the engine o, this screen protects the
starter frame and all the controls placed in its closeness end stop point
2-2 On-Site Movements
To Next Page
Loading...