© İnnosis Makine 46
• Check all the nuts and bolts for ghtness.
• Check all rollers on the track frame for oil leaks and wear. • Check the state and the
integrity of the pile extractor
• Consult the engine and hammer manual for relave tasks
Maintenance to carry out aer 50 operang hours:
All Engine and Hydraulic Oil Filters must be changed.
1.3- Maintenance to carry out aer 250 operang hours.
Aer about 250 operang hours (running), it will be necessary to substute the engine oil, the
engine oil lter and the hydraulic oil lter. For such task follow the instrucons described in the
appropriate paragraph of the present manual.
Checks and maintenance to carry out every 250 operang hours
Do the following checks aer 250 operang hours and every 250 working hours:
• Change the engine oil.
• Change all oil lters.
• Check and restore the nitrogen level of the hammer (25-30 bar)
• Check the condion of all the adhesive labels, and replace as needed.
• Check the condion of all the hoses for damage or leaks .
• Check the automac return of the control levers and the carrying out of all the
funcons.
• Check the hydraulic oil level in the tank by using the sight glass, should be ½ ll.
• Check the oil level in the Track nal drive units.
• Check the ghtening of the crawler tracks.
• Check the wear-out and the state of the crawler tracks. For the check and the
substuon of these tracks, consult the instrucons described in the relave paragraph.
• Apply grease to all the present grease nipples on the Pile Driver with the hand pump.
• Clean the chain and oil as required.
• Check the anchorage pins at each end of the li chain for wear and replace them if
damaged. Replace each 12 months period.
• Check all the nuts and bolts to ensure these are ght.
• Check the liquid level in the baery.
• Check the state and the integrity of the pile extracon chain;
• Consult the engine and hammer manual for the concerning transporng.
Checks and maintenance to carry out every 500 operang hours
To Next Page
Loading...