PROGRAMMING
4-4
4.3 Entering into Programming Mode
1. Turn on the MiniRAE 2000 monitor and wait for the
“Ready..” message or the instantaneous reading
display “0.0 ppm” message displayed.
2. Press and hold down both [N/-] and [MODE] keys for
three seconds to enter programming mode. This delay
is to prevent the user from entering programming mode
by accident.
3. The first menu item “Calibrate/select Gas?” will be
displayed.
4. Release both [MODE] and [N/-] keys simultaneously
to start the programming mode
5. Press [N/-] key to scroll to the next menu item of the
programming menu. Press [Y/+] key to select the
displayed menu item.
The following Sections 4.4 - 4.7 describe the details of
each menu options.
To Next Page
Loading...
