PROGRAMMING
4-25
4.6.3 Clear Data
This function will erase all data stored in the non-volatile
datalog memory. Note: This function does not change
STEL, TWA, Peak, Minimum and run time values, which
are stored in the regular data memory.
1. “Clear Data?” is the third sub-menu item in the Datalog
sub-menu.
2. Press the [Y/+] key to clear the datalog memory. The
display shows “Are you sure?”
3. Press the [Y/+] key again to confirm erasure of all the
datalog memory.
4. Press the [N/-] or [MODE] key to exit without clearing
the datalog memory and move to the next datalog sub-
menu.
To Next Page
Loading...
