PROGRAMMING
4-33
4.7.5 Change User Mode
There are two different user modes: Display and Program
that can be selected from the programming menu.
1. “Change User Mode?” is the fifth sub-menu item in the
Monitor Setup menu (Table 4.7).
2. Press the [Y/+] key; the display shows the current user
mode selected.
3. Press the [Y/+] key to accept the currently displayed
user mode. Press [N/-] key to toggle to the alternate
user modes. Press [MODE] to exit this sub-menu and
move to the next monitor setup sub-menu.
4. If there is any change to the existing selection, the
display shows messages “Program change” and “Are
you sure?” Press [Y/+] to confirm the change or press
[N/-] or [MODE] to discard the changes and move to
the next sub-menu.
CAUTION: If the user mode is changed to Display mode,
the user can no longer enter the programming mode.
Therefore, the user can not change the user mode back to
Program mode in normal mode.
To restore the user mode back to Program mode, turn the
unit off and back on in Diagnostic Mode. Next enter
Program mode by holding the [MODE] and [N/-] keys for
three seconds. Enter the password at the prompt (the
default is 0000). Once program mode is entered, go to the
“Change Monitor Setup” / “Change User Mode” and
change the mode back to Program.
An alternative way to change Display mode back to
Program mode is through the PC and the ProRAE-Suite
software (see Section 5.5.1).
To Next Page
Loading...
