PROGRAMMING
4-34
4.7.6 Change Date
The MiniRAE 2000 monitor is equipped with a real time
clock (RTC). The user can enter the correct date and time
(see 4.7.7) for the real time clock.
1. “Change Date?” is the sixth sub-menu item in the
Monitor Setup menu.
2. Press [Y/+] and the display shows the current date
“mm / dd / yy” with the left most digit of the date
flashing.
5. To modify this value, use the [Y/+] or [N/-] key to
change the digit value and press the [MODE] key
momentarily to advance to the next digit. The flashing
digit will move on to next digit to its right. Repeat this
process until the new date and time values are entered.
Press and hold the [MODE] key for 1 second to exit
data entry mode.
4. If there is any change to the existing value, the display
shows “Save?” Press [Y/+] to confirm the new value or
press [N/-] or [MODE] to discard the changes and
move to the next sub-menu.
To Next Page
Loading...
