PROGRAMMING
4-13
4.4.5 Modify Cal Memory
If the current cal memory number selected is not memory
0, users will be prompted whether to modify the settings of
the selected cal memory. Press [Y/+] to modify the cal
memory and [N/-] to go to the next sub-menu.
Once [Y/+] is pressed the LCD display will show the
current memory number, current Gas selected and prompt
user for acceptance of current gas selected.
1. Press [N/-] to modify the gas selection if desired. Or
press [Y/+] key to skip the change of gas selection, and
proceed to the next sub-menu.
2. After pressing [N/-], display shows “Copy gas from
library?” Press [Y/+] to accept or [N/-] for the next
sub-menu, “Enter Custom gas?”
3. In the “Copy gas from library” submenu, use [Y/+] and
[N/-] keys to scroll through the selections in the library.
Press [MODE] key momentarily to select the gas. The
display shows ”Save?” Press [Y/+] to save or [N/-] to
discard the changes and proceed to next sub-menu.
4. In the Custom gas sub-menu, the user can enter the gas
name. Press the [Y/+] or [N/-] key to cycle through all
26 letters and 10 numerals. Press the [MODE] key
momentarily to advance to the next digit. The flashing
digit will move to the next digit to the right. Repeat
this process until all digits (up to 8 digits) of the custom
gas name is entered.
To Next Page
Loading...
