Rae MiniRAE 2000 - Change User ID

PROGRAMMING
4-31
4.7.3 Change User ID
The user can enter an 8-digit alphanumeric user ID in the
programming mode. This user ID will be included in the
datalog report.
1. “Change User ID?” is the third sub-menu item the
Monitor Setup menu.
2. Press the [Y/+] key and the display shows the current
user ID: “User ID = xxxxxxxx” with the left most digit
flashing.
3. Press the [Y/+] or [N/-] key to cycle through all 26
letters and 10 numerals. Press [MODE] momentarily
to advance to the next digit. The flashing digit will
move to the next digit to the right. Repeat this process
until all 8 digits of the new user ID are entered.
4. Press and hold the [MODE] key for 1 second to exit the
data entry mode.
5. If there is any change to the existing user ID, the
display shows “Save?” Press the [Y/+] key to accept
the new user ID. Or press the [N/-] key to discard the
changes and move to the next sub-menu.