PROGRAMMING
4-41
4.7.13 Set Temperature Unit?
The temperature display can be switched between
Fahrenheit and Celsius units.
1. “Set Temperature Unit?” is the thirteenth sub-menu
item in the Monitor Setup menu.
2. Press the [Y/+] key, and the display shows the current
setting: “Temperature Unit = Fahrenheit?”
3. Press the [Y/+] key to accept the currently displayed
value. Press [N/-] to select the sub-menu “Temperature
Unit = Celsius?” Press [MODE] to exit this sub-menu
and return to the first sub-menu in Table 4.7.
4. If there is any change to the existing selection, press the
[Y/+] key and the display will show “Save?” Press the
[Y/+] key to save the change and return to the first sub-
menu in Table 4.7 or press the [N/-] key to discard and
return to Step 3..
To Next Page
Loading...
