PROGRAMMING
4-26
4.6.4 Change Data Period
The datalog period can be programmed from 1 to 3,600
seconds (1 hour).
1. “Change Data Period?” is the fifth sub-menu item in
the Datalog sub-menu.
2. Press the [Y/+] key and the display shows “Datalog
Period = XXXX” with the left-most digit flashing,
where “XXXX” is the previously stored data log
period.
4. To modify this period, starting from the left-most digit,
use the [Y/+] or [N/-] key to change the digit value and
press the [MODE] key momentarily to advance to the
next digit. The flashing digit will move to the next
digit to the right. Repeat this process until all 4 digits
of the new period are entered. Press and hold the
[MODE] key for 1 second to exit data entry mode.
5. If there is any change to the existing value, the display
will show “Save?” Press [Y/+] to accept the new value
or [N/-] to discard the changes and move to the next
sub-menu.
To Next Page
Loading...
