PROGRAMMING
4-22
4.6.1 Reset Peak/Minimum
This function will reset the peak and minimum stored in
the data memory. Note: this function will not clear the
STEL or TWA data.
1. “Reset Peak/Minimum?” is the first sub-menu item in
the Datalog sub-menu (Table 4.6).
2. Press the [Y/+] key to reset the Peak/Minimum Values.
The display shows “Are You Sure?”
3. Pressing the [Y/+] key again will reset the values. The
display shows “Peak/Minimum Cleared” and moves to
the next submenu.
4. Press the [N/-] or [MODE] key to exit without resetting
the values and move to the next sub-menu.
To Next Page
Loading...
