Rae MiniRAE 2000 - Change Alarm Limits

PROGRAMMING
4-16
4.5 Change Alarm Limits
In this menu, the user can change the high and low alarm
limits, the STEL limit and the TWA limit (see Table 4.5
below). Press the [Y/+] key and the display shows the
current gas selected followed by the first sub-menu item
below.
Table 4.5
Alarm Limit Sub-Menu
Change High Alarm limit?
Change Low Alarm limit?
Change STEL limit?
Change TWA limit?
1. Scroll through the Alarm Limit sub-menu using the
[N/-] key until the display shows the desired limit to be
changed, e.g.,”High limit?”, “STEL limit?”, etc.
2. Press the [Y/+] key to select the desired limit and the
display shows a flashing cursor on the left-most digit of
the previously stored alarm limit.