PROGRAMMING
4-17
3. To modify this limit value, use the [Y/+] or [N/-] key to
change the digit value and press the [MODE] key
momentarily to advance to the next digit. The flashing
digit will move to the next digit to its right. Repeat this
process until the new limit value is entered. Press and
hold the [MODE] key for 1 second to exit data entry
mode.
4. If there is any change to the existing value, the display
shows “Save?” Press [Y/+] to accept the new value
and move to the next sub-menu. Press [N/-] to discard
the changes and move to the next sub-menu.
0010.0
To Next Page
Loading...
