PROGRAMMING
4-36
4.7.8 Change Lamp
There are three UV lamps with different photon energies
available for the PID sensor: 9.8 eV, 10.6 eV and 11.7
eV. The user can select any one of the lamps from the
programming mode.
1. “Change Lamp Type?” is the eighth sub-menu item in
the Monitor Setup menu (Table 4.7).
2. Press the [Y/+] key; the display shows the current PID
lamp selection.
3. Press the [Y/+] key to accept the currently displayed
lamp. Press [N/-] key to scroll through the sub-menu
for other lamp selections. Press [MODE] to exit this
sub-menu and return to the next sub-menu in Table 4.7.
4. If there is any change to the existing selection, the
display will show “Save?” Press [Y/+] to save the new
selection or press [N/-] or [MODE] to discard the
change and return to the next sub-menu in Table 4.7.
To Next Page
Loading...
