Operation Quantron E 4
48
Recalibrating the speed signal:
You can overwrite an existing profile or create a profile in an empty memory lo-
cation.
1. Highlight the desired memory location with the function key below it in the
Tractor (km/h) menu.
2. In the Tractor (km/h) menu, highlight the New Calibration field using the Ar-
row Keys.
3. Press the Enter key.
The calibration menu Tractor (km/h) is displayed.
Figure 4.22:Tractor (km/h) calibration menu
[1] Tractor name field
[2] Display origin of speed signal
[3] Display of number of impulses over 100 m
[4] Automatic calibration submenu
[5] Radar impulse transducer
[6] Wheel impulse transducer
4. Highlight the tractor name field and press the Enter key.
5. Input the name of the profile.
Input of text into the operator panel is described in section 4.9.1:
Text input,
page 75.
6. Select the transducer for the speed signal.
For radar impulses press the function key F1.
For wheel impulses press the function key F2.
The transducer is shown in the display.
NOTICE
The name is limited to 16 characters.
We recommend using the name of the tractor for ease of understanding.
To Next Page
Loading...