Operation Quantron E
51
4
a) Select Auto km/h + Auto kg:
1. Switch on the control unit Quantron E.
2. Switch from the Hopper configuration menu to the AUTO/MAN operation
menu.
3. Highlight the AUTO km/h + Auto kg selection field.
4. Press the Enter key.
The Weigh Quantity window appears.
5. Case a: Refill
The flow factor setting is retained.
The remaining fertiliser volume is increased by the refilling volume.
Case b: New fertiliser
The flow factor is reset to 1. If necessary, you can enter the required flow
factor value later on. See 4.4.3:
Flow factor, page 36.
6. Highlight the required type of filling and press the Enter key to return to the
operating screen.
b) Procedure when spreading with Auto km/h + Auto kg:
1. Each time you switch on the Quantron E, use the kg button to switch to the
Weigh Quantity menu and weigh the volume of fertiliser using Refill or New
Fertiliser.
See 4.2.3:
Weigh quantity, page 27
2. Press the Enter key.
3. Carry out the fertiliser settings:
Application rate (kg/ha)
Working width (m)
4. Pour the fertiliser in.
The Weigh Quantity window appears in the display.
n CAUTION
Incorrect metering by pressing the ESC key
You must not press the ESC key. Doing so will result in serious
errors in the application rate/metering.
To confirm the weighing function, always press the Enter
key.
NOTICE
If the volume of fertiliser added to an empty hopper is less than 200 kg, switch
to the AUTO km/h + Stat. kg or Auto km/h mode.
To Next Page
Loading...