Operation Quantron E 4
52
5. Highlight the action carried out in the display:
Refill:
Continue spreading with the same fertiliser.
The flow factor setting is retained.
The remaining fertiliser volume is increased by the refilling volume
New fertiliser: Flow factor set to 1.0 and a new flow factor regulation will
follow.
ESC: Quit
The remaining fertiliser volume is increased by the refilling volume.
6. Press the Start/Stop key.
The spreading starts.
NOTICE
On uneven, hilly terrain, application rates below 30 kg/min should be spread in
the Auto km/h + Stat. kg (weighing spreader) or Auto km/h (other fertiliser
spreader types) mode.
NOTICE
If, after confirming the Weigh Quantity window the fertiliser settings are chan-
ged before starting spreading, then these changes to the settings should be car-
ried out with the spreader stopped and horizontal.
NOTICE
If, during running (i. e. travelling to the field) a change is made to the fertiliser
settings, before starting to spread you must actuate the kg/Weigh Quantity but-
ton with the vehicle stopped.
NOTICE
We recommend that the flow factor be displayed in the operating screen (see
4.8.2:
Display config., page 68), in order to watch the flow factor regulation
whilst spreading.
NOTICE
In the event of problems with the regulating behaviour of the flow factor (blok-
kages, ...), at a standstill and after resolution of the fault use the kg button to
switch to the Weigh Quantity menu and call up the New Fertiliser function.
To Next Page
Loading...