Raven SmarTrax MD User Manual (English)

Other manuals for Raven SmarTrax MD

Questions and Answers:

L
Lori GravesAug 26, 2025
What to do if Raven Tractor Accessories SmarTrax MD will not disengage when steering wheel is turned?
- C
  Cynthia GarciaAug 26, 2025
  If your Raven Tractor Accessories SmarTrax MD system continues to steer when you turn the steering wheel, the disengage setting might be incorrect; adjust it in the field computer. Another possibility is a damaged encoder. To check this, go to the SmarTrax Sensor Setup screen and manually turn the steering wheel while monitoring the Wheel Angle value. If the wheel angle doesn't change, replace the mechanical drive.
N
Neil AndersonAug 25, 2025
What to do if Raven Tractor Accessories SmarTrax MD will not find the guidance line?
- S
  Shawn MorrisAug 26, 2025
  If your Raven Tractor Accessories SmarTrax MD system is not finding the guidance line, make sure that the SmarTrax MD system is engaged. If you are using GL1DE speed filter, disable it. Also, try increasing the LA Aggressiveness setting and the OL Sensitivity setting in increments of 1, allowing at least 30 seconds between adjustments.
R
rogersbridgetAug 25, 2025
What to do if Raven Tractor Accessories SmarTrax MD will not engage?
- R
  Richard MartinezAug 25, 2025
  If your Raven SmarTrax MD system won't engage when you press the foot/enable switch, several things could be wrong. First, check the LEDs on the node to ensure proper communication. Second, there might be an active error in the SmarTrax MD system. Third, make sure the foot/enable switch cable is securely connected and not faulty. Fourth, check the operator presence switch connections. Fifth, ensure the SmarTrax MD master switch is in the “ON” position. Finally, set a new guidance line if none is currently set.

Raven SmarTrax MD Specifications

General

Operating Voltage	12V DC
Steering System	Hydraulic
Assisted Driving Modes	Pivot
Steering Accuracy	Sub-inch with RTK
Compatibility	CAN Bus
GPS Receiver	Integrated
Display	Compatible with Raven Viper 4+
Power Requirements	12V DC
Communication	CAN
Update Rate	10 Hz
Operating Temperature	-20°C to 55°C
Weight	Varies with configuration