Manual #016-0159-956
17
7. The Zero Yaw Rate screen displays. Make sure that the vehicle is at a
complete stop before pressing the Right arrow key to zero the Yaw
Sensor.
8. Next, select the preferred units of measurement for your SmarTrax
controller. Press the Left or Right arrow to select either Feet-Decimal,
Feet-Inches, or Metric. Press the Down arrow to set the value
9. Use the Left or Right arrows to program the fore or aft position of the
GPS antenna with respect to the rear axle. If the GPS antenna is in front
of the rear axle, enter a positive value for this setting. When you are
finished, press the Down arrow to save the displayed setting.
To Next Page
Loading...
Need help?
General
