Manual #016-0159-956
55
System disengages when
the auxiliary hydraulic
functions are operated.
1. Turn the Relief Valve in.
2. Turn the screw on the needle valve out.
3. Turn the screw on the pressure switch in.
Vehicle veers in one
direction while the
system engages.
1. Decrease the Line Acquire Aggressiveness.
2. Inspect the SPS and re calibrate if necessary.
3. Decrease the valve timing.
4. Check and confirm the minimum turning
radius and wheelbase of the vehicle.
5. Confirm that the lightbar swath and width and
offset settings are correct.
Operational Problem Solution
To Next Page
Loading...
