RED DSMC OPERATION GUIDE
COPYRIGHT © 2014 RED.COM, INC 955-0020_V5.2, REV-G | 107
SELF TEST
The Self-Test menu includes: Enable Sensor Test Pattern and Touchscreen.
ENABLE/DISABLE SENSOR TEST PATTERN
The Sensor Test Pattern feature is only used during manufacturing. The sensor test pattern is a white screen.
TOUCHSCREEN
To perform a touchscreen self-test, follow the instructions below:
1. Go to Menu > Settings > Maintenance > Self Test.
2. Select Touchscreen.
A grid of green squares displays on the touchscreen.
3. Touch each box with your finger.
Each green box turns blue.
4. To exit the self-test, perform one (1) of the following actions:
‒ Touch all of the boxes, so that they are all blue.
‒ Press and hold the touchscreen.
‒ Press the Enter or Menu button on the DSMC Side Handle or REDMOTE.
RESTORE SYSTEM
Restore System changes all settings to the factory default values. To perform a System Restore, follow the
instructions below:
1. Go to Menu > Settings > Maintenance.
2. Select Restore System.
3. Select Yes on the screen that asks you to confirm the System Restore.
The camera turns off.
4. Turn on the camera.
NOTE: After performing a system restore, pair the REDMOTE to the camera again.
To Next Page
Loading...
Need help?
General
