RED DSMC OPERATION GUIDE
COPYRIGHT © 2014 RED.COM, INC 955-0020_V5.2, REV-G | 151
SET UP STEREO/3D CONFIGURATION
This section describes basic procedures for connecting two (2) DSMC BRAINs in a Master/Slave configuration
for 3D operation.
NOTE: When providing the signals to a Stereo Image Processor (SiP) for verifying 3D alignment, set the HD-SDI
monitor output on both cameras to have the same overlay configuration.
NOTE: Genlock is ONLY possible between BRAINs that can achieve the same project time base and sensor
frame rate.
To set up a Stereo/3D setup, follow the instructions below.
1. On both cameras, set the desired project time base and sensor frame rate.
2. On both cameras, follow the instructions in “Sensor Sync” on page 147 to achieve Sensor Sync genlock
status.
The GEN and SYNC indicators in the Lower Status Row illuminate green.
3. Follow the instructions in “Set Up Master/Slave Operation” on page 148 to set Master and Slave camera
settings.
4. On both cameras, follow the instructions in “Set Reel Number, Camera ID, and Camera Position” on page
150 to prepare media and camera settings.
REQUIRED CABLES
790-0163: Master/Slave Gig-E Cable
790-0154: 3BNC-to-00 LEMO Sync Cable (required per camera)
To Next Page
Loading...
