COPYRIGHT © 2014 RED.COM, INC
RED DSMC OPERATION GUIDE
955-0020_V5.2, REV-G | 114
HDR MENU
NOTE: HDR mode cannot be modified when in Magnify 1:1 mode or when test signals are enabled.
NOTE: You cannot use HDR mode when:
‒ A Motion Mount is installed.
‒ A Sensor Sync Mode (Genlock or MoCo) is enabled.
‒ Speed Ramp mode is enabled.
‒ A Frame Processing mode (Frame Summing or Frame Averaging) is enabled.
By default HDRx is disabled, and the HDR indicator in the Lower Status Row is gray.
To enable HDRx, follow the instructions below:
1. Go to Menu > HDR.
2. Select HDRx.
The HDR text in the Lower Status Row turns white.
3. Select the number of Stops. The range is 1–6, and the default is 2.
4. Select which track you want the display to show:
‒ A Track: This track shows the video with the selected F stop and exposure settings applied.
‒ X Track: This track shows the video with the additional stops applied.
NOTE: For more information, see the High Dynamic Range Video with HDRx article available at www.red.com/
learn/red-101/hdrx-high-dynamic-range-video.
To Next Page
Loading...
Need help?
General
