COPYRIGHT © 2014 RED.COM, INC
RED DSMC OPERATION GUIDE
955-0020_V5.2, REV-G | 138
CHARGE THE REDMOTE
A fully discharged REDMOTE battery requires approximately six (6) hours to fully charge. You can use the
REDMOTE while it charges.
Charge the REDMOTE using either of the following methods:
Dock the REDMOTE to a camera or rear module.
Connect the REDMOTE to a computer, cell phone charger, or other sufficient power source using the
RED Mini-USB-to-USB cable. If the power supply does not provide enough voltage, an “Error Charging”
message displays.
CHARGE INDICATORS
The battery indicator in the lower right of the REDMOTE LCD indicates remaining battery life and charge status.
Green: The battery has a sufficient charge, or is fully charged.
Yellow: The battery is somewhat depleted and should be recharged soon.
Red: The battery is nearly discharged and should be recharged immediately. Wireless communication is at
risk of being lost when the battery indicator is red.
CUSTOMIZE REDMOTE SETTING MENUS
When operating the REDMOTE in Local mode, you can configure the settings displayed in each status window.
Settings can be assigned to one (1) of the five (5) pages available under Soft Menu Buttons (4-8).
To customize settings, follow the instructions below:
1. Ensure the DSMC is on and wirelessly connected to the REDMOTE.
2. If the REDMOTE is in Remote Mode, press Button 2 to toggle to Local Mode.
3. Select the Soft Menu Button (4-8) page you would like to set the desired setting on.
4. Use the Directional Keys to move the red cursor to the desired setting location.
5. Press Button 3.
6. Select Setup Slot and press ENTER.
7. Select the desired setting from the available list.
8. Press Enter.
To Next Page
Loading...
Need help?
General
