RED DSMC OPERATION GUIDE
COPYRIGHT © 2014 RED.COM, INC 955-0020_V5.2, REV-G | 149
C. For Target, select None.
D. Go to Menu > Settings > Setup > Communication and select the Ethernet tab.
E. Verify the Enable Camera to Camera check box is selected.
The LAN indicator in the Lower Status Row illuminates green.
NOTE: Cameras can also be set up in Master/Master configuration. To set as Master/Master, set Target to All
on both cameras, allowing either camera to make changes and control record start/stop.
Slave Settings
To Next Page
Loading...
