RED DSMC EPIC - Page 91

RED DSMC OPERATION GUIDE
COPYRIGHT © 2014 RED.COM, INC 955-0020_V5.2, REV-G | 91
CAMERA NAME
Use the Camera menu to set up a unique identifier for your camera (or a group of cameras). All command
filtering happens on the receiver side of the communication link. Use camera names and group names to
address commands to a specific camera or group of networked cameras.
 Name: Enter a unique camera name to use in network communications. The field is limited to eight (8)
characters.
 Group: Enter a group name to identify the camera as a member of a group of devices. The field is limited to
eight (8) characters, and the default name is DEFAULT.
 Target: Specify which devices the camera can send commands to:
‒ All: The camera can send commands to all devices on the network.
‒ None: The camera can only receive commands. The camera cannot send commands.
‒ Custom: The camera can send commands to a specific camera/device (enter the name of the camera/
device in the Custom text box) or a specific group (enter the name of the group in the Custom text box).
The camera/group name must match the name entered in the Name/Group field of the target device(s).
SERIAL PROTOCOL
The camera can communicate to external devices via the CTRL and the GIG-E connectors (camera-to-camera
communication is possible only via GIG-E or the REDLINK Bridge).
Select one of the following protocols from the Serial Protocol drop-down menu:
 None (default)
 Element Technica
 3ality SPC 7XXX
 REDLINK Command Protocol
 RCP 3D Metadata