To Next Page

To Previous Page

RED DSMC OPERATION GUIDE: EPIC/SCARLET

INSTALL THE RED SWITCHBLADE-M

WARNING: Before installing or removing the RED Switchblade-M, you MUST turn off the BRAIN.

REQUIRED TOOL: T10 TORX driver

1. Turn off the BRAIN.

2. Use a T10 TORX driver to remove the single screw located at the bottom of the BRAIN side plate (if the

side plate is installed).

3. Rotate the BRAIN side plate upwards to disengage the lip at the top of the side plate from the BRAIN, and

remove the BRAIN side plate.

4. Insert the lip on the RED Switchblade-M into the slot where the lip of the BRAIN side plate was installed.

5. Press the Switchblade-M down flush along the side of BRAIN.

6. Tighten the thumbscrew until finger-tight, then enage the thumbscrew mechanism.

REMOVE THE RED SWITCHBLADE-M

WARNING: Before installing or removing the RED Switchblade-M, you MUST turn off the BRAIN.

REQUIRED TOOL: T10 TORX driver

1. Turn off the BRAIN.

2. Disengage the thumbscrew mechanism.

3. Loosen the thumbscrew until the Switchblade-M detaches from the BRAIN.

4. Pull the bottom of the RED Switchblade-M away from the BRAIN to disengage the tension lip.

5. Remove the RED Switchblade-M from the BRAIN.

6. Insert the tension lip on the BRAIN side plate into the recess on the side of the BRAIN.

7. Install the appropriate screw at the bottom of the BRAIN side plate using a T10 TORX driver. DO NOT

exceed 70 in-oz, or damage may occur.

‒ EPIC side plate screw: M3x0.5 x 8 mm

‒ SCARLET side plate screw: M3x0.5 x 5.5 mm

WARNING: DO NOT OVERTIGHTEN.

Other manuals for RED Epic

Questions and Answers:

Need help?

Do you have a question about the RED Epic and is the answer not in the manual?

General