◈ L-Tool
1. Turn the clamp knob on the left side of the clamp and pull the clamp and spacer block to take it out.
2. Fix a ring on flat surface of the rotation clamp. (Ring Outer Diameter Max.18mm)
3. Press the button and go to the expert menu mode.
4. Press button, and when menu appears on the LCD window, then press
and hold button until it beeps (more than 3 seconds) to run the menu.
5. Select the “5.Pointer/L-Tool” then press and hold button until it beeps (more than 3 seconds) to run
the menu.
6. When message appears on the LCD window like below, pull the L-Tool down by L-Tool line 1. Then press
button.
7. The tool draws cross (＋) lines on the materials.
8. When message appears on the LCD window, pull up the L-Tool. And the laser pointer is
turned on
To Next Page
Loading...