6. Press button to turn on the laser pointer on the clamp.
7. Move the laser pointer to the center of the dot by using the direction key.
8. Press and hold the button until it beeps (more than 3 seconds) to confirm that the setting is saved.
9. When menu appears on the LCD window like below, select the “CENTER” by using the buttons.
10. Press and hold the button until it beeps (more than 3 seconds) to confirm that the setting is saved.
11. Tool will be moved to the position stored in the button.
5) Saving New Clamp Origin Position
1. Press button to move to flat mode.
※Menu will be changed if you enter ring inner/outer diameter mode menu.
2. Press button and go to the expert menu mode.
3. Press button, and when menu appears on the LCD window, then press
and hold button until it beeps (more than 3 seconds) to run the menu.
4. Select a “Clamp” and “Origin” what you want by using the
direction key, then press and hold button until it beeps (more than 3 seconds) to move to the origin.
5. Press button to turn on the laser pointer on the clamp.
6. Move the laser pointer to the point what you want by using the direction key, and
To Next Page
Loading...