REPLIGEN CTech FlowVPX System - Figure 49. Transmission Check Button in Instrument Control Menu

39
DOC0211
eRev. 1.08/15/2023
User Guide
CTech™ FlowVPX® System
11. How to Run a Transmission Check (Cary 60)
Note: The ViPER software must be first installed and connected to successfully run a transmission check.
1. Run the ViPER software on the computer by double-clicking the appropriate program icon for the connected light source,
titled ViPER (Beams) or ViPER (Cary 60), located on the desktop.
2. Type the username and password credentials in the indicated fields.
3. Click Validate VPT to launch application.
4. Flow Cell must be unloaded to begin.
• Always ensure that no sample is flowing through the cell before unloading the Flow Cell. Otherwise, this may cause
damage to the system and to the surrounding environment.
5. Click Transmission Check on the Instrument Control to begin the process.
Figure 49. Transmission Check Button in Instrument Control Menu
6. Click Continue and follow the on-screen prompts. Click Step Completed to proceed.